The Roach Roller Bed Inclined Floor-To-Floor Belt Conveyor Model 796RB is designed to provide transition floor-to-floor when conveying unit loads and Model 796RB uses less horsepower than a slider conveyor belt. The incline conveyor provides higher load capacity, and the reversible flow and nose-over allows for simple adjustments for inclines 0-35°. The roller bed belt conveyor will convey heavier loads than slider bed conveyor due to less friction. Each roller helps minimize belt friction, thus providing for greater capacities. Similar to the slider bed conveyor the roller bed also maintains its overall length as the belt tension is increased. Shown with optional supports, knee braces, chain driven feeder and right hand drive. All units furnished standard with left hand drive.
Rubber belt incline conveyors handle and process bulk materials. Bulk powders, granules, flakes or pellets are supplied and delivered from a variety of different containers. Rubber belt incline conveyors also convey small items that could fall between rollers, irregular bottom surface materials, and bags that would sag between rollers.
Specifications of the Roach Roller Bed Inclined Floor-To-Floor Belt Conveyor Model 796RB:
Belting: PVC-120 black. Safety pop-out roller: standard on both ends, 1.9" dia. X 16 GA. Steel roller.
Carrier rollers: 1.9" dia. X 16 GA. Model196S.Steel rollers, Model196S.
Squaring rods: Adjustable rods drive pulley: 4" dia. With 1-3/16" on underside of bed allow frame to be dia. Shah or 8" dia. Width 1-7 /16" dia. Squared for improved belt tracking and shah, both machine crowned and fully are standard on all units over 30'. Fully lagged.
Bed: 7" x 1-1 /2" x 12 GA.
Tail pulley: 4" dia., machine crowned, channel frame. Bed sections attached with 1-3/16" dia. Shah. With couplings and floor supports.
End drive: Allows one-direction (unit) bearings: all pulley bearings are operation; add optional center drive for precision, heavy duty, lubricated, ball reversible application. Bearing units come with cast iron housings.
Take-up: Screw type unit at tail pulley provides 12" belt take-up.
Belt speed: 60 fpm, constant.
Return rollers: 1.9" dia. X 16 GA. Steel, modei196s, adjustable.
Roller chain: Drive pulley is driven by no. 50 roller chain for 1-1 /2 HP or less and no. 60 chain on larger drives. Chain take-up is provided on motor base.
Motor drive: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
Electrical controls: optional.
The system integrators at Thomas Conveyor can help to design the correct roller bed inclined floor to floor belt conveyor system for your application. Contact us today to discuss the Roach Roller Bed Inclined Floor-To-Floor Belt Conveyor Model 796RB.